Phones answered 24/7Portland, ME
Call (833) 490-5225
(833) 490-5225
Urgent? Phones answered 24/7

Frozen and burst pipe water damage in Portland

Water from a split supply pipe is extracted and the walls, floors and ceilings it ran through are dried to readings.

  • Storm surge and flood water
  • Ice dams and frozen pipes
  • Old plaster and brick drying

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Burst Pipe Damage

Frozen and Burst Pipe Water Damage: what it covers

Quick answer

A frozen pipe does its damage when it thaws: the split opens and supply water runs under pressure until the main is shut. Portland Water Damage Restoration extracts that water and dries the walls, floors and ceilings it reached across Portland and Cumberland County, with phones answered 24/7 through the winter.

Frozen and Burst Pipe Water Damage illustration for Portland, ME

Water expands as it freezes, and a closed pipe gives it nowhere to go, so the ice forces the wall of the pipe apart. Copper splits along a seam, plastic cracks, and a fitting can be pushed off its joint. While everything is still frozen the pipe holds, which is why so many of these calls come on the first mild morning after a cold snap, when the ice plug melts and the opening starts to run.

What follows is different from a flood. Flood water arrives once and stops; a split supply pipe keeps delivering clean water at mains pressure until someone closes a valve. A break inside a wall or above a ceiling can put water through two floors before it is found, and if the house was empty it can run for days. Knowing where your main shut-off is, and that it turns, is the single most useful thing a homeowner here can do before winter.

The pipes that freeze in Portland are the ones in cold places: an outside wall with little or no insulation, an unheated basement or crawl space, a bulkhead, a vacant apartment in a divided house. Roughly 46 percent of the city's housing was built before 1940, and in houses of that age the plumbing was threaded through walls that were never designed around it. That is why the first job on arrival is finding where the water went, not just where it came from.

Service area
Portland & Cumberland County
Availability
Phones answered 24/7, emergencies first

What makes the price of a burst pipe job go up or down?

How long the water ran, how many rooms and floors it reached, whether the break was in a wall or in the open, what the finishes are made of, and how many units are involved. Everything is measured and approved before work starts.

Time is the first factor, because a pipe that ran for ten minutes and one that ran overnight produce very different jobs in the same house. Then comes how many surfaces are wet: water that crossed a floor and down into a ceiling below has doubled the work of water that stayed in one room.

Construction is the next factor. Plaster, old softwood floors and heavy framing need longer monitored drying than modern board, and a break inside a wall means opening and reinstating finishes. In a divided house or an apartment building each affected unit needs its own readings and its own access arrangements. We publish no figures, since no price specific to Portland is sourced; a technician measures the wet area, lists what is coming out, and explains the price before beginning.

Will my insurance cover a frozen pipe?

Often, but coverage typically depends on heat having been maintained in the building. A house left unheated through a cold spell is the situation insurers most commonly push back on, so a record of the heating and the damage is worth having from the first hour.

The reasoning is that a frozen pipe in a heated house is sudden and accidental, while one in a building left cold is treated as a failure of care. That matters most for seasonal homes and vacant rentals, where keeping some heat on and the water shut off is the practical defense.

What a restoration crew can do is document: dated photos before anything is moved, the moisture readings through drying, and a written list of what was removed. An adjuster decides from that evidence and nobody in restoration can promise an outcome. Complaints about an insurer's handling go to the Maine Bureau of Insurance, and the insurance claim documentation page covers how the record is built.

How do I stop pipes freezing in the first place?

Keep heat in the building, insulate pipe runs in cold spaces, open cabinet doors under sinks on outside walls, and drain or shut off anything that serves an unheated area. For a house left empty, shut the water off at the main and drain the system.

Most freezes happen in a space the heating does not reach: a bulkhead, a crawl space, a closed-off room, a wall cavity with no insulation behind the pipe. Pipe insulation helps where air temperature is only marginal, but it slows heat loss rather than adding heat, so a genuinely cold space needs warmth or an empty pipe.

A trickle of water running overnight on the coldest nights keeps a vulnerable run moving and is a reasonable short-term measure. For a seasonal property the better answer is to have nothing in the pipes at all, which the island and seasonal home water damage page goes into for properties that sit empty over winter.

Why does a small split cause so much damage?

Because it is fed by mains pressure and does not stop. A crack a fraction of an inch wide delivers water continuously, and once it is inside a wall or above a ceiling it spreads through insulation and framing well beyond the visible damage.

A flood has a finite volume; a supply leak has a supply. That is the whole difference, and it is why the same amount of visible staining means something worse on a pipe job than on a storm job. The water is also clean, which sounds reassuring but means it soaks deeply into porous material rather than sitting on the surface.

Hidden paths make it worse. Water follows wiring, pipe chases and the gaps around a chimney, so it can appear two rooms away from the split. This is why a technician maps the wet area with meters and a thermal camera instead of working from what can be seen.

How fast should a burst pipe be dealt with?

Immediately. Shut the water off, then call: phones are answered 24/7 and a crew is dispatched as fast as one is available. Clean water becomes a mold and odor problem within days, and wet materials that could have been dried start needing replacement.

The first hours decide how much of the house is saved. Water that is extracted while it is still on the surface does far less harm than water that has had a day to soak into plaster, subfloor and insulation, and in a heated house mold can begin on damp organic material within a few days.

Call (833) 490-5225 as soon as the supply is off, even if the leak looks small. A technician can tell you over the phone what to move and what to leave, and the job is queued while you are getting a plumber to the split.

Warning signs

Signs you need frozen and burst pipe water damage

Shut the water off at the main before anything else, and if you cannot find or turn the valve, say so on the phone and you will be talked through the alternatives. Do not use electrical fittings, outlets or ceiling lights in a room where water is coming through, and stay away from anything wet near a panel. Never thaw a frozen pipe with an open flame or a blowtorch, which starts house fires every winter; a hair dryer or a space heater at a safe distance is the sensible method. Leave a sagging wet ceiling alone and keep people out from under it.

  • A tap that runs to a trickle or gives nothing at all during a cold spell
  • A bulge, a frost patch or a split visible on an exposed pipe
  • Water running inside a wall or a ceiling that you can hear but not see
  • A ceiling stain that appears and grows within a few hours
  • Water coming out at a baseboard, a floor edge or around a door frame
  • A water meter that keeps turning with every tap in the house closed
  • Paint or wallpaper blistering in a vertical line down a wall
  • A warm spot or a damp carpet over a heating pipe run
Our process

How our frozen and burst pipe water damage visit works

  1. Stop the water first

    Nothing else matters until the supply is off. On the first call a technician talks you through finding the main shut-off, or shutting the valve nearest the leak, and turning off a water heater if the break is on the hot side. A plumber makes the repair, and the two jobs are coordinated rather than queued.

  2. Find out where the water traveled

    Clean water under pressure spreads along the easiest path, which is usually a floor cavity, a stud bay or a pipe chase. The crew meters the walls and floors, uses a thermal camera to show wet areas behind the finish, and maps the extent before anything is cut. The wet area is nearly always larger than the stain.

  3. Extract and remove what will not dry in place

    Standing water is extracted from floors and from carpet and pad, and water trapped in a cavity is let out through openings cut in the least damaging places. Soaked insulation, chipboard and the lower band of wallboard usually come out; plaster and solid timber are judged on readings. Each removal is photographed and explained first.

  4. Dry the structure, not just the room

    Air movers and dehumidifiers are placed to work the cavities as well as the surfaces, sometimes with drying mats on a hardwood floor or small vents into a closed wall. Readings are taken on the first visit and on each return until the framing, plaster and subfloor reach dry targets. Equipment is moved as the numbers change.

  5. Document the loss and check the rest of the house

    You get dated photographs, the moisture log and a written scope for your insurer. Before the equipment leaves, other vulnerable runs in the building are looked at, because a house that froze once in a cold snap often has a second pipe that nearly did. That walk-through costs nothing and has saved repeat damage.

Options

Types and options for frozen and burst pipe water damage

A split in an exterior wall

Pipework run in an outside wall freezes first in an old house, especially behind a kitchen sink or a bathroom on a north face. The leak soaks the wall cavity and the finish on both sides, and water tracks down to the floor below. Opening the wall is usually unavoidable, and it is done in planned cuts rather than by chasing the stain.

A break in an unheated basement or bulkhead

Exposed runs in a cold basement are the most common freeze point of all, and here the water falls directly onto the floor rather than into a finish. That makes extraction easier but spreads water across stored contents and into the base of walls. It is also the version most likely to flood a finished basement room.

A pipe that burst in an empty building

A vacant apartment, a seasonal house or a building between tenants can run for days unnoticed. Damage reaches ceilings, floors and the units below, and by the time it is found mold is often already starting. These jobs begin with a careful walk of the whole building, because the break may be a long way from the worst damage.

A heating system leak in freezing weather

Water in a hot water heating loop can freeze in a cold zone or in a radiator in an unheated room, and the system then leaks when it is refilled or restarted. The water may be rusty and leave staining, so cleaning is part of the job. The heating repair itself is a plumber's work.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent frozen and burst pipe water damage, send the form and we'll call you back.

Cumberland County

Why frozen and burst pipe water damage is different in Southern Maine

Winter here reliably delivers the conditions a freeze needs, and the risk is concentrated in the oldest housing. A pre-1940 house in Portland typically has plumbing added long after it was built, sometimes run through an exterior wall or a cold cupboard because that was the easy route at the time. Those are the runs that split.

Divided houses are a particular pattern in this city: large older homes converted into apartments, each with its own heating habits. One unit left cold while the others are warm is enough to freeze a shared run, and water from an upper unit reaches every floor below. Access to several units at once is often the slowest part of the job.

The city's working waterfront and its shore towns add the seasonal angle. A camp, cottage or island house shut up for the winter has no one to notice a split, and the water can run until a neighbor sees it or the bill arrives. Those buildings are better drained than heated, and a burst there is usually a bigger job than the same split in an occupied home.

Related

Ice Dam Water Damage

Water backed up under shingles by an ice dam is traced through the ceiling and walls, then dried to readings.

Ceiling and Drywall Water Damage

A brown ring overhead means water is already in the cavity. The ceiling is opened where it has to be, drained, dried and read back.

Island and Seasonal Home Water Damage

A pipe that lets go in an empty cottage runs until somebody opens the door. The loss is sized, extracted and dried, with everything recorded for an owner who is away.

Guides

Read before you book

FAQ

Frozen and Burst Pipe Water Damage FAQs

The pipe froze but has not burst. What should I do?

Open the nearest tap so meltwater has somewhere to go, then warm the area gently with a hair dryer or a space heater kept clear of anything flammable. Never use a flame. If you cannot reach the frozen section, or it is in a wall, shut the water off at the main and get a plumber before it thaws.

Can my hardwood floor survive a burst pipe?

Sometimes. Boards that were wet briefly and can be dried from above and below, sometimes with drying mats, often come back. Boards that cupped badly, lifted at the seams or sat wet for days usually have to come up, and the subfloor underneath has to be checked either way.

Do I need a plumber or a restoration company?

Both, and in that order for the water itself. A plumber repairs the pipe; a restoration crew deals with everything the water soaked. The two run alongside each other, and the restoration documentation covers what was wet, not the plumbing repair.

Can you dry a wall without taking it apart?

Often, yes. Small vents or holes in inconspicuous places let air into a cavity so it can be dried in place, which saves the finish. Where insulation is saturated or the material has already broken down, opening it is the only honest option, and you see the readings behind that call.

What about the mess in the apartment below mine?

Water that has gone through a floor is part of the same loss and is dried as one job, with separate readings and photographs for each unit. Access has to be arranged with whoever lives there, which is usually what sets the pace in a divided house.

Will a dehumidifier from the hardware store do the job?

Not for a structure. A domestic unit is sized for room air, not for pulling water out of plaster, framing and subfloor, and it has no way of telling you when the material is dry. Restoration dehumidifiers are paired with air movers and with meter readings that show whether drying is actually progressing.

WhatsApp