Phones answered 24/7Portland, ME
Call (833) 490-5225
(833) 490-5225
Urgent? Phones answered 24/7

Flood water extraction and pumping in Portland

Standing water is pumped and extracted, trapped water is pulled from floors and walls, and the building is readied for drying.

  • Storm surge and flood water
  • Ice dams and frozen pipes
  • Old plaster and brick drying

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Extraction and Pumping

Flood Water Extraction and Pumping: what it covers

Quick answer

Extraction is the first physical stage of any flood job: getting bulk water out of the building so drying can begin. Portland Water Damage Restoration pumps standing water, lifts trapped water out of floors and wall bases, and clears the silt behind it in Portland and Cumberland County, with phones answered around the clock.

Flood Water Extraction and Pumping illustration for Portland, ME

Every flood job starts the same way, whatever put the water there. Until the bulk water is gone, dehumidifiers have nothing useful to do and the wet area keeps growing as water wicks sideways into dry framing. Extraction is not the glamorous part of restoration, but it decides how much of the building survives: a basement pumped within hours loses far less than one pumped a day later.

There is more to it than a pump on a hose. Water sits in three places after a flood: on the floor, inside porous materials like carpet pad, plaster and insulation, and in voids under floors and behind wall bases. A pump only reaches the first. Specialised extraction tools reach the second, and the third needs openings cut in the right places. Judging where water is hiding is most of the skill.

In Portland that judgment is shaped by what the buildings are made of. Old basements have rubble stone or brick walls and often an uneven floor with low corners, so water does not pool where you expect it, and the wall itself holds a share of it. Pumping an older basement dry means working the low spots, then working the wall.

Service area
Portland & Cumberland County
Availability
Phones answered 24/7, emergencies first

What decides the cost of extraction and pumping here?

Volume and depth come first, then the floor area that has to be cleared, how far the discharge has to travel, how reachable the space is, and whether the water was clean, gray or contaminated. The scope and the price are explained and agreed before work starts.

Depth and square footage set how long pumping and extraction run, and that is the largest part of the work. A shallow film across a large floor can take as long as a deep pool in a small one, so a technician measures the area rather than eyeballing the puddle.

After that it is access and water quality. A basement reached by a narrow stair, a crawl space entered through a hatch, or a discharge line that has to be run a long way all add time. Contaminated water adds cleaning and protective work that clean water does not need. There is no published price specific to Portland that we would stand behind, so no figure appears here: a technician measures, lists what is coming out, and gets your approval first.

Why not just let a wet basement dry on its own?

Because standing water keeps moving into dry material and because damp organic matter starts growing mold within days in a heated building. Evaporation alone is far slower than extraction, and the longer water sits the more of the structure has to be removed.

Water travels toward dry material. Left alone, a pool in one corner of a basement wets the whole floor slab, the base of every wall it touches and anything stored against those walls. Each hour of that spreads the eventual scope of work outward.

There is also the air. A wet basement raises humidity through the whole house because warm air rises and damp air follows it, so upstairs plaster and contents get damp too. Extraction removes liquid water quickly; the structural drying and dehumidification stage then deals with what is left in the materials.

Can you pump a basement while water is still coming in?

Sometimes, and sometimes it is the wrong thing to do. If ground water is high around the foundation, drawing an old basement down fast can put uneven pressure on the wall. A technician judges it on the day and may stage the drawdown.

A masonry basement wall is holding back saturated ground. The water inside is partly balancing that pressure, so emptying it in one go is not always wise on an old rubble wall, and the level is often brought down in steps instead while the wall is watched.

The other case is a drain or a river still feeding the space, where pumping continuously just keeps pace until the source drops. That is still worth doing, because it keeps the level off the lowest contents and mechanical plant, but it is explained as holding ground rather than finishing the job.

What happens to the water that is pumped out?

It is discharged away from the building to a point where it will not return to the foundation, and where it does not run onto a neighbor's land. Contaminated water is handled differently from clean water, and the route is chosen before pumping starts.

Discharging a basement into the flower bed beside it simply recharges the ground that is leaking in, so the hose is run as far as the site allows, usually toward a street gutter or a lower part of the lot. On a tight peninsula lot with buildings close together, that route takes planning.

Where the water contains sewage the handling changes, because mixed flow cannot simply be put onto the ground. Those jobs are covered on the sewer backup cleanup page, and the cleaning that follows them is a different standard of work from clean-water extraction.

Do you take contents out, and what happens to them?

Yes, where they are in the way or at risk. Items that can be saved are moved to a dry part of the property or out of the building, and what has been ruined is photographed and recorded before it is removed, so there is a record for a claim.

Basements hold what houses have no other room for: stored boxes, old furniture, tools and heating equipment. Clearing the floor is usually necessary before extraction can be done properly, and the clearing is the part most owners want to be in the room for.

The rule is photograph first, then move. Soaked cardboard, chipboard furniture, mattresses and carpet pad rarely come back; solid wood, metal and sealed plastic usually do. Anything with a document, a photograph or a sentimental value in it gets set aside rather than binned, and you make the final call on it.

Warning signs

Signs you need flood water extraction and pumping

Do not step into standing water in a basement until you know where the electrical panel and any outlets are relative to the water line, and never reach in to switch off a pump or an appliance that is submerged. Keep extension leads and portable pumps out of the water unless they are rated for it. If a fuel oil tank has been in the water, or you can smell oil, leave the building and call (833) 490-5225 from outside. Wet concrete stairs and silt-covered floors are slippery, so take them slowly.

  • Standing water of any depth in a basement, cellar or ground-floor room
  • A floor drain that is backing up instead of taking water away
  • Carpet that squelches underfoot or shows a dark waterline at the skirting
  • Water visibly seeping in where the basement wall meets the floor
  • A sump pump running continuously, or silent with water still rising
  • Grit and silt spread across a basement floor after the water has drained
  • A damp line creeping upward on plaster or on painted masonry
Our process

How our flood water extraction and pumping visit works

  1. Decide whether pumping can start safely

    A technician asks where the water is relative to the electrical panel, the furnace and any fuel tank before anyone steps in. If the water is still rising, or the ground outside is saturated, pumping too fast can be the wrong move in a masonry basement. The order of operations is set on the first call.

  2. Pump the bulk water out

    Submersible pumps handle depth and volume, discharging to a point where the water will not run straight back to the foundation. On a flooded basement the level is usually drawn down in stages rather than all at once. The discharge route is chosen with the yard and the neighbors in mind.

  3. Extract what the pump cannot reach

    Once the depth is gone, water remains in the last film on the floor and inside porous materials. Weighted and wand extraction tools pull it from carpet, pad and the surface of a slab, which removes far more water than fans ever could. Every gallon lifted here is a gallon the dehumidifiers do not have to evaporate.

  4. Clear the silt and the debris

    Flood water leaves a layer of sediment that sets hard if it dries in place and holds moisture while it is wet. The floor is shovelled, squeegeed and rinsed where the finish allows it. Soaked cardboard, stored paper and anything that has collapsed is bagged out at this stage.

  5. Open the trapped voids and hand over to drying

    Wall bases, boxed-in pipework and the cavity under a floor are checked with meters and opened where water is sitting out of reach. Then the drying plan goes in: equipment placed, readings logged, and a written scope left with you. Extraction and drying are one continuous job, not two separate visits.

Options

Types and options for flood water extraction and pumping

A flooded older basement

This is the most common call here. Water arrives through the wall, around the floor edge or up through a drain, and the stone or brick wall soaks up a share of it on the way. Pumping is straightforward; the slow part is proving the wall and the floor are actually drying. Stored contents usually have to come out before the floor can be cleared properly.

A ground floor over a crawl space

When the water is under the living floor rather than on it, there is nothing to pump from inside the house. Access is through a hatch or an exterior vent, and the water is pumped and extracted from below while the floor above is metered from the top. Wet insulation under the floor is usually the thing that has to come out.

Large-volume commercial extraction

In a shop, restaurant or office the volume is bigger and the clock is commercial. Truck-mounted or high-capacity portable extraction moves more water per hour, and the work is sequenced so part of the premises can stay in use where that is safe. Documentation is heavier too, because contents and stock losses have to be recorded as they are removed.

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what flood water extraction and pumping should cost.

Cumberland County

Why flood water extraction and pumping is different in Southern Maine

A flooded basement in Portland is often a masonry basement. Rubble stone and brick walls, dirt or old poured floors and low corners mean water hides in places a smooth modern slab does not have, and a technician works the low spots with a meter rather than trusting the eye.

The city's drivers of flooding are seasonal and they change the work. Winter brings ice dams and split pipes, the spring thaw and heavy rain fill basements through the ground, and autumn-to-winter nor'easters push sea water in from the harbor side. Extraction is the same first step in all three, but what has to be cleaned afterwards is not.

Buildings on and around the peninsula sit at very different heights above the water, from the lowest waterfront floors to the hills above them. Two houses on the same street can have entirely different exposure, which is why the first visit includes a look at where the water entered rather than only where it ended up.

Related

Sump Pump Failure Water Damage

A pump fails at the worst moment by definition, during thaw or a storm. The basement is pumped out, cleaned and dried on readings.

Crawl Space and Basement Moisture

A damp stone cellar is not a flood, and it is not normal either. The source is traced, the space is dried, and the reason it stays damp is addressed.

Guides

Read before you book

Flood Insurance and Storm Surge on Casco Bay

A homeowners policy excludes flood, so rising water from the bay, a river or surface runoff is covered only by a separate flood policy through the National Flood Insurance Program or a private carrier.

How to Hire a Water Damage Contractor in Maine

No Maine state license specific to water damage restoration was found, and a restoration industry roundup reports no state general contractor or mold remediation license requirement either.

FAQ

Flood Water Extraction and Pumping FAQs

Can I rent a pump and do this myself?

You can move bulk water that way, and if it is clean water and you are confident about the electrical situation, getting the level down helps. What a rented pump will not do is lift water out of the pad, the wall base and the subfloor, which is where most of the remaining damage lives. That part needs extraction tools and meters.

How long does extraction take?

On a typical flooded basement the pumping and extraction stage is often a matter of hours rather than days, once a crew is on site. The drying that follows is what runs longer. A technician gives you a realistic picture on the first visit, based on depth, area and materials.

Will my floor finish survive?

It depends on the material and on how long it was wet. Sealed concrete and tile usually come through, solid wood sometimes does, and carpet pad, laminate and chipboard underlay rarely do. Nothing is removed without showing you the readings behind the decision.

Do you work at night and at weekends?

The phone is answered 24/7 and a crew is dispatched as fast as one is available. Floods do not keep office hours, and extraction is the part of the work where hours matter most. We do not promise a specific arrival time, because that depends on where crews are working.

Is the water in my basement considered contaminated?

It depends where it came from. Clean supply water is one thing, ground water that has crossed soil is another, and anything with sewage in it is treated as contaminated throughout. A technician categorises it on arrival, because that decides the cleaning, the protective equipment and what can be saved.

What if my sump pump failed and that is why the basement flooded?

Extraction is the same, and the pump itself is then worth looking at before the next storm. That situation is covered on the sump pump failure water damage page, including what tends to fail and what gets checked afterwards.

WhatsApp