Phones answered 24/7Portland, ME
Call (833) 490-5225
(833) 490-5225
Urgent? Phones answered 24/7

Coastal storm surge flood damage in Portland, ME

Salt water driven in by surge and tide is removed, the building is rinsed and cleaned, and framing is dried to readings.

  • Storm surge and flood water
  • Ice dams and frozen pipes
  • Old plaster and brick drying

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Storm Surge Damage

Coastal Storm Surge Flood Damage: what it covers

Quick answer

Storm surge flooding is sea water pushed inland by wind and high tide rather than rain falling on a roof. Portland Water Damage Restoration answers these calls for Portland and Cumberland County around the clock, removes the water and the salt it leaves behind, and dries structures with monitored equipment rather than by guesswork.

Coastal Storm Surge Flood Damage illustration for Portland, ME, with the river and a lighthouse in the background

On January 13, 2024 the tide gauge in Portland read 14.57 feet MLLW, above the 14.17-foot mark set in 1978, a reading the National Weather Service published as preliminary and subject to review. Sources disagree over whether to call it the record or simply among the highest ever recorded here, and either way what residents saw was the same: water standing on Commercial Street at Chandler's Wharf, across Marginal Way, and up Franklin and Congress Streets.

That storm, and the one three days before it on January 10, show why surge is its own kind of water damage. It was three causes at once: heavy rain already running off the ground, an astronomical high tide, and strong onshore wind holding the sea against the land. Nothing about the building had failed. The water arrived at a level the doors and foundation walls were never built to stop.

Surge water also leaves something behind. Salt stays in plaster, in brick joints, in old softwood sills and in insulation long after the room looks dry, and it keeps those materials damp by pulling moisture out of the air. That is why a technician treats sea water as a separate problem from clean water.

Service area
Portland & Cumberland County
Availability
Phones answered 24/7, emergencies first

What makes the price of a storm surge job go up or down?

Depth and the area covered matter most, then how much of the building is salt-contaminated, how old the materials are, how easily equipment can reach the space, and whether it is one home or several units. Every scope is explained and approved before work starts.

The biggest driver is simply how much of the building the water touched. A few inches across one room is a different job from two feet across a ground floor, because the number of square feet to extract, clean and dry sets how much equipment runs and for how long. Depth also decides whether the wall base and insulation have to come out.

After that it is the building itself. Old plaster, brick and heavy framing dry more slowly than modern board, so they need longer monitoring, and carrying equipment down to a tight peninsula basement takes time a walk-in basement does not. So does the number of separate units in a building, each with its own readings and its own occupant.

No figure appears on this site, and that is deliberate: no price specific to Portland is published anywhere we can stand behind, and a national average would tell you nothing useful about your house. A technician measures the wet area, lists what is coming out and what is being dried, and explains the scope and the price before any work begins.

Is storm surge flooding covered by homeowners insurance?

Usually not. Standard homeowners policies exclude flood, which is why surge losses are generally handled through separate flood coverage rather than the main policy. Water that entered because wind opened the building is treated differently from water that rose up to it.

Flood is a named exclusion on standard homeowners policies, and cover for rising water comes from the National Flood Insurance Program or a private flood policy instead. That distinction matters in a surge event, because the same storm can cause both kinds of loss in one building: wind lifting a roof slate and letting rain in, and sea water coming through a door at high tide.

What a restoration company can do is document which was which, with dated photos, moisture readings and a written scope, so an adjuster is looking at evidence rather than a description. The insurance claim documentation page covers how that record is built, and the guide on flood insurance and storm surge around Casco Bay goes through the coverage question in more detail. No restoration company can promise how a claim will be decided; if you believe you have been treated unfairly, the Maine Bureau of Insurance is the agency that takes complaints.

Why is salt water harder to dry than clean water?

Salt stays in the material after the water leaves and draws moisture back out of the air, so a wall can read damp long after it should have dried. It also corrodes metal fixings and keeps finishes from bonding. Rinsing is part of the drying.

Dissolved salt is hygroscopic, which is a plain way of saying it attracts water. Left in plaster, masonry or softwood it holds the material damper than the surrounding air would, which in a wet coastal season can mean a wall that never quite dries.

Salt also goes after metal: nails, joist hangers, ductwork and the fixings inside a wall corrode faster once it is sitting on them, and paint applied over a salted surface tends to blister later. A technician watches for crystalline deposits as the wall dries, because they are the clearest sign salt is still in the material.

How soon after a flood tide should the work start?

As soon as the water has stopped rising and the building is safe to enter. Phones are answered 24/7 and a crew is dispatched as fast as one is available. Waiting for the next low tide is sometimes the right call, but waiting for days is not.

Wet materials get worse by the hour rather than the day. Water moves out of the flooded area into dry framing, insulation stays saturated, and in a heated building mold growth starts on damp organic material within days. The sooner extraction and airflow are in place, the less of the building has to be opened up and replaced.

There is a practical limit on a coastal job: if the tide is still coming in, a crew cannot usefully pump a space that is refilling. What the first call does is start everything that can be done anyway: moving contents, planning the scope, staging equipment. Call (833) 490-5225 when you see water and the timing is worked out around the tide.

What did the January 2024 storms mean for buildings here?

They flooded streets and ground floors across the waterfront on an unusually high tide, and FEMA disaster 4764 covered the January 9 to 13, 2024 storms with Cumberland and York Counties eligible. The useful lesson is that surge reaches buildings rain never would.

The combination behind those days was rain, an astronomical high tide and strong wind arriving together. The level recorded at the gauge exceeded the 1978 figure that had stood as the local benchmark. It is history rather than a forecast, and it says nothing about what any one tide will do next.

What it does tell an owner is which parts of a building are exposed. If water reached a doorway, a basement window or an air vent then, that is the route it takes again. The guide on what to do first after the January 2024 storm flooding sets out the order of the first few hours.

Warning signs

Signs you need coastal storm surge flood damage

Do not wade into a flooded basement or ground floor if the water is near the electrical panel, the furnace or any outlet, and do not switch anything on to see whether it still works. Treat surge water as contaminated: it has crossed streets and drains, so keep children and pets out and wash thoroughly after any contact. Leave a stuck or bulging door alone if water is standing behind it. If you smell fuel oil, leave the building and call from outside.

  • A tide line of silt or grit on a wall, a door frame or the legs of furniture
  • Standing or receding water in a basement or ground-floor room after a high tide
  • Plaster that stays cool and damp to the touch for days after the water has gone
  • White powdery deposits appearing on brick or on a stone foundation wall as it dries
  • Paint or wallpaper lifting in a band a foot or two above the floor
  • Wet batt insulation sagging out of a basement ceiling or a rim joist
  • A furnace, water heater or electrical panel that was standing in water
Our process

How our coastal storm surge flood damage visit works

  1. Make the call and establish whether the building is safe to enter

    Before anyone goes into a flooded ground floor the power and fuel situation has to be understood. A technician asks whether water reached the panel, the furnace or the meter, and whether it has stopped rising with the tide. If it has not, the first visit is planned around the tide rather than against it.

  2. Remove the water and the silt that came with it

    Surge water carries sand, grit and whatever was on the street with it, so pumping alone leaves a layer behind. Pumps and extraction units take out the standing water, then the floor is shovelled and squeegeed clear before the sediment dries into the finish.

  3. Open up and take out what salt water has ruined

    Saturated insulation, carpet, pad, particle board and the lower band of wallboard are cut out and bagged, because salt water does not leave them sanitary or sound. Plaster and solid wood are judged on readings instead, and much of it can be saved. Every removal is photographed and explained before a cut is made.

  4. Clean and rinse the salt off what is staying

    Framing, masonry and concrete that are being kept get cleaned and rinsed rather than simply dried, so the salt load comes down instead of sitting in the pores. It is done before the drying equipment goes in, not after.

  5. Dry to readings, then document the loss

    Air movers and dehumidifiers run until the framing, masonry and plaster reach dry targets, with meter readings taken on each visit rather than a fixed number of days. Dated photos, the moisture log and a written scope are left with you for an adjuster, and repairs are quoted separately once the structure is confirmed dry.

Options

Types and options for coastal storm surge flood damage

Wharf-side and waterfront ground floors

Buildings along the working waterfront sit low by design, close to the water they were built to serve. When the tide tops the edge of the wharf the water comes in across the floor rather than up through it, which means contents and fit-out take the damage first. Drying is complicated by the open volume and by hard finishes that hide wet subfloor beneath, and the work is staged so the premises can reopen in sections where that is possible.

Peninsula houses with stone or brick basements

An older Portland basement with a rubble stone or brick foundation holds water in the wall itself, not only in the room. Once the standing water is out, the wall keeps releasing moisture into the space for weeks unless it is dried deliberately. Dehumidification here is slower, and readings are taken in the masonry rather than only in the air.

A ground floor that flooded and drained with the tide

Some surge events fill a room for an hour or two and then drain away as the tide drops, leaving a building that looks almost untouched. The water still got into the wall base, the subfloor and the insulation, and those materials hold it. A moisture survey tells you how far it traveled, which is nearly always further than the tide line suggests.

Job stories

Typical jobs for coastal storm surge flood damage

Typical job
Illustration: Typical: salt water across a ground floor near the working waterfront

Typical: salt water across a ground floor near the working waterfront

What homeowners notice
A nor'easter arriving on a high tide pushes salt water over a low threshold and across a ground-floor room, leaving a dark line on the plaster and grit along the baseboards.
What we do
The crew confirms power to the area is off, pumps from the lowest point, lifts and bins the saturated pad and carpet, rinses the lower plaster and masonry to deal with the salt, and opens the wall only where the meter says water is held. Air movers and dehumidifiers run to target.
What to expect
The owner is left with dated photographs, a reading log and a removal list, and is told plainly that surge is a flood loss and sits outside a standard homeowners policy.

one extraction visit, then drying visits over several days typical visit

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what coastal storm surge flood damage should cost.

Cumberland County

Why coastal storm surge flood damage is different in Southern Maine

Portland sits on a peninsula in Casco Bay with the Fore River on one side and Back Cove on the other, so the city has water on three sides of its oldest ground. That geometry is why surge here is not only a shoreline problem: water comes up the harbor, over the lowest streets and into basements set back from the shore, and it arrives through a storm drain as readily as over a threshold.

Roughly 46 percent of the city's housing was built before 1940, which is among the oldest housing in the country. That means lime plaster on wood lath, brick and rubble stone foundations, and softwood sills low on the wall. Those materials absorb water deeply and give it up slowly, so a surge job in Portland runs longer on monitoring than the same depth of water in newer construction.

Surge season here runs from autumn into winter, when nor'easters line up with high tides, while the spring thaw and heavy rain bring a different kind of flooding altogether. An owner on the water has two separate things to prepare for: keeping sea water out at the lowest openings, and getting ground water away from the foundation.

Related

Flood Water Extraction and Pumping

Standing water is pumped and extracted, trapped water is pulled from floors and walls, and the building is readied for drying.

Commercial and Waterfront Water Damage

A flooded shop or restaurant loses trade every hour it is shut. Water is removed, the building is dried in stages, and the whole loss is documented.

Insurance Claim Documentation

A claim is decided on evidence. Photographs, daily moisture readings and a record of what came out are kept from the first visit onward.

Guides

Read before you book

Flood Insurance and Storm Surge on Casco Bay

A homeowners policy excludes flood, so rising water from the bay, a river or surface runoff is covered only by a separate flood policy through the National Flood Insurance Program or a private carrier.

FAQ

Coastal Storm Surge Flood Damage FAQs

Is storm surge the same thing as a flood for insurance purposes?

In coverage terms, water that rises and enters the building is generally treated as flood, and flood is excluded from standard homeowners policies. That is why separate flood cover exists. The distinction turns on how the water got in, not on how bad the damage looks.

Can my hardwood floor be saved after sea water came across it?

Sometimes, if it was wet briefly and can be dried from below as well as above. Boards that cupped or lifted at the seams usually come up, and the subfloor has to be checked either way. Salt in the wood weighs on that decision.

Do I need to replace my furnace or water heater if it stood in salt water?

That is a decision for a heating technician rather than a restoration crew, and it is usually driven by how far up the unit the water went and whether controls and burners were submerged. Do not run it in the meantime, and photograph the water line on the unit before anything is moved.

How long does drying take after a ground floor floods?

It depends on depth, materials and how quickly extraction started, and in older plaster and masonry it tends to run longer than in modern board. Readings decide it, not a calendar, and a technician gives an expected range on the first visit and updates it as the meters come down.

Does the same crew handle the drain backups that happen in the same storm?

Yes, though it is handled as a different kind of water. Sea water coming back through storm drains is covered on the combined sewer and Back Cove drain backup page, because mixed flow has to be cleaned as contaminated water rather than rinsed.

Do you work on commercial buildings along the waterfront?

Yes, and the differences are scale and keeping part of the premises usable while drying runs. That work is set out on the commercial and waterfront water damage page.

WhatsApp